Please select the appropriate option
Ensure the correct button on remote is being pressed
On/Off
Airflow
Oscillation
Point the remote directly at the front of the machine while pressing the button.
Test the machine
Use the middle control toggle to adjust the speed of the airflow.
Try the button on the Main body.
On/Off
Oscillation
Airflow
Ensure the correct button on remote is being pressed
Point the remote directly at the front of the machine while pressing the button.
On/Off
Airflow
Oscillation
Ensure the correct button on remote is being pressed
On/Off
Airflow
Oscillation
Check for blockages
Remove the loop amplifier from the telescopic stand by pulling gently on the loop.
Remove the telescopic stand from the Main body by turning the telescope anti-clockwise.
Check the loop and telescope for any debris or blockages.
Ensure the seal is not damaged or missing and no debris visible around the Main body.
Reassemble and test the machine.
The fan has a strong, smooth airflow when switched on. The airflow should be strong enough to lift a sheet of newspaper past 45 degrees.
Hold a newspaper approximately 2 meters (6' 6'') away from the product with the airflow control dial turned to maximum.
Remove the loop amplifier from the telescopic stand by pulling gently on the loop.
Remove the telescopic stand from the Main body by turning the telescope anti-clockwise.
Check the loop and telescope for any debris or blockages.
Ensure the seal is not damaged or missing and no debris visible around the Main body.
Reassemble and test the machine.
Check the feet are attached correctly
Ensure all the feet are attached to the base of the machine.
Place the fan on a flat, non-slip surface.
Ensure the correct button on remote is being pressed
On/Off
Airflow
Oscillation
Ensure the correct button on remote is being pressed
On/Off
Airflow
Oscillation
Point the remote directly at the front of the machine while pressing the button.
Try the button on the Main body.
On/Off
Airflow
Oscillation
Wipe the machine
The following areas should be checked and cleaned to maintain the machine's performance.
Loop amplifier - clean with a dry cloth.
Main body - clean with a dry cloth
Shroud - clean with a dry cloth or soft brush
Test the remote control
Point the remote directly at the front of the machine while pressing the button.
On/Off
Airflow
Oscillation
Assemble your machine
Lower the Main body onto the base, aligning the arrows.
Turn the base clockwise until it clicks into place.
Lower the telescope onto the base, aligning the arrows.
Once aligned, turn the telescope clockwise to lock.
Lower the loop amplifier onto the telescope.
The remote control can be magnetically attached to the top of the loop.
Power
To operate, point the remote control toward the front of the base and press the standby ON/OFF button.
Alternatively press the standby ON/OFF button on the Main body.
Please note, the remote control can be magnetically attached to the top of the loop.
Oscillation
Toggle oscillation on or off with the remote.
Airflow
Airflow can be set by the airflow buttons on the remote.
Adjust the loop
Lift or push air loop up or down for required airflow height.
- This is the Standby button on the appliance and it is used to turn the machine on/off.
- This is the oscillation button on the appliance and it is used to start/stop the fan turning.
- This is the central airflow control on the appliance and it is used to adjust the speed of the airflow.
Serial number location
The serial number can be found on the base of the machine.
How to tilt the loop
Gently move the loop backward or forward for the required airflow angle.
Further help
AM03 Pedastal™
